Electro Industries EB-MO-15 WarmFlo Outdoor Reset Modulating Electric Heating Boiler-51,000BTU

As part of our EB-MO WarmFlo Electric Boiler Series, the Midsize electric boiler offers complete application flexibility. Features - 205 F hi-limit, compact, easy to install, ASME "H" Stamp, and parcel post shippable. The focus of this new design is to provide the installer with an easy access control board, a smaller, more compact design, and built-in temperature control. All of these features add up to a elctric radiant heating boiler that is easier to use and install, which in turn saves you money. Mid-Size EB-MO WarmFlo Electro Boiler is Modulates at a tighter temperature control-Modulating.WarmFlo represents the controlling mechanism within your heating system to "smooth out" the energy capacity within the furnace or boiler to make sure it adjusts to the load capacity requirement at each thermostat call for heat.

WarmFlo is the 21st century controller for your heating system. It applies to any electric or dual heat system, new or retrofit. This article presents only two applications - electric boiler and heat pump - do not overlook other applications and the many WarmFlo benefits.

EB-MO-15 WarmFlo Electro Industries Electric Radiant Heating Outdoor Reset Modulating Boiler at a glance:

Outstanding Efficiency

Outdoor Sensor-Outdoor Reset

Lasting Performance

Easy Monitoring

Reliable Safety

Advanced Control System.

Multiple Applications

Easy Installation, Service and Maintenance

Compact, Lightweight Design and Zero clearance to Combustibles

EB-MO-15 WarmFlo Electro Industries Electric Radiant Heating Outdoor Reset Modulating Boiler Other Standard Features :

EB-MO Series Electro Industries WarmFlo Electric Radiant Heating Modulating Boiler Warranty

2 years parts / 20 years Heating Elements/ 20 Years Vessel

The majority of the Electric Boilers, hydronics heating, installations have several zones or thermostats in various rooms. When one thermostat calls for heat it represents only a partial load to the boiler. Perhaps we could use the analogy of an automobile accelerator pedal to relate to WarmFlo. WarmFlo controlling your boiler would act as an automatic accelerator pedal. Basically all other low cost boilers have an on/off device, like your automobile ignition switch, referred to as an aquastat. When you have a call for heat and the aquastat is on the boiler allows it to run at full energy capacity, totally independent of the load on the boiler. Just like the boiler is sized for full energy capacity to heat your house on the coldest day with all thermostats calling simultaneously, your automobile engine has the horsepower or energy capacity to carry 5 adult people with probably 500 pounds in the trunk at 100 miles per hour when the accelerator is all the way down to the floor. You would not be very satisfied with your automobile if it did not have an accelerator pedal (it would be 100% on). In this analogy you would start out at the stop sign by simply turning on the ignition switch (thermostat call for heat). It would use all its energy up to 30 miles per hour, you would then turn off the ignition switch (thermostat satisfied), coasting to 20 miles per hour, then turn the ignition switch back on and continue the process. With a lightly loaded automobile at 30 miles per hour the accelerator is approximately 15% of the way pressed to the floor. It certainly is much more reliable, safe, and comfortable operating at the 15% point. Likewise with WarmFlo, if it is 50° outside and only one thermostat is calling for heat (bedroom representing a small load) the boiler may only run at 15% capacity, controlled by WarmFlo.