Local Pickup FAQ's
Hover to zoom
1 Of 5
Crown Boiler FW - 355K BTU - 84.5% Thermal Efficiency - Hot Water Oil Boiler - Chimney Vent - Burner Sold Separately
Model:
FW-4
+
Share This Product
Recommended Accessories
Expert Recommended Accessories
Selected by Ken, our Expert
Required Accessories
9
These accessories are required to properly setup/install this product.
Optional Accessories
10
Features
- Cast Iron Heat Exchanger
- The Crown FW includes a durable cast iron heat exchanger that circulates hot flue gases through the heat exchanger three times, resulting in a more efficient boiler.
- Durable Jacket
- A powder coated, textured and insulated jacket allows the FW to provide powerful heating in even the toughest conditions.
- Venting Options
- Pressurized for forced draft or chimney draft venting, the FW is able to adapt to your installation requirements.
The Crown FW is a cast iron, scotch marine-style boiler for use with light oil, gas, or a light oil-gas combination. Featuring a cast iron, 3-pass heat exchanger, the FW is designed to maximize heat transfer from flue gases to the boiler water. The FW includes cast iron push nipples and boiler sections, woven glass ropes between sections, swing open burner door and removable stainless steel baffles. Exclusively designed for forced hot air circulation, the FW boasts impressive BTU output while using as little energy as possible.
California residents see
Warning: This product can expose you to chemicals including Chromium (hexavalent compounds) which is known to the State of California to cause Cancer.
For more information go to: www.p65Warnings.ca.gov
Specifications
FW-4
Overview
Product Category
Boiler
UPC
645504320003
General Information
Product Line
FW
Product Category
Boiler
Medium
Medium
Medium refers to the substance that carries heat through the heating system. Systems are either designed to use either Hot Water or Steam as a medium, and components are usually specific to one or the other.
Hot Water
Heat Exchanger Material
Cast Iron
Fuel Type
Fuel Type
To create heat, some form of fuel is required. Fuel Type specifies what the product uses as an input to create heat.
Oil/Natural Gas
Combustion Type
Combustion Type
Condensing appliances use leftover thermal energy from combustion gases to heat water in a secondary heat exchanger, resulting in higher efficiency and lower exhaust temperature.
Conventional
Vent Type
Vent Type
Products that use combustion (burning) of fuel to create heat also create potentially dangerous gasses that need to be exhausted (AKA "Vented"). Depending on the product, venting can be done via a chimney, through a side wall, or use a second vent to provide fresh air to the appliance.
Chimney Vent
DHW Production
DHW Production
DHW (Domestic Hot Water) is potable water for uses other than space heat. Some boilers are able to provide DHW "out of the box", while others can do so with the purchase of optional accessories.
No
Modulating/Staging
Modulating/Staging
Stages are unique speeds or levels that equipment can operate at. More stages allow for better fine-tuned control of output, which improves comfort and efficiency. Modulating equipment can operate across a range of levels, giving the highest level of fine-tuned control. Learn More
Staging
Mount Type
Floor
Minimum Altitude
0 Feet
Maximum Altitude
2000 Feet
Assembly Type
Packaged
Includes Pump
No
Burner Model
Sold Separately
Performance
Maximum Input Capacity
Maximum Input Capacity
The Maximum Input Capacity describes how quickly the appliance will use fuel when delivering it's maximum capacity. The units may change depending on the fuel being used.
433000 BTU
Input Rate
3 GPH
DOE Heating Capacity
DOE Heating Capacity
Also referred to as Gross Output, this is the output of a boiler after accounting for combustion efficiency. We recommend sizing hot water boilers based on the DOE Heating Capacity.
355000 BTU
Net I=B=R Capacity
Net I=B=R Capacity
I=B=R, also referred to as Net Output or AHRI Capacity, is the rated heat output of a boiler after accounting for combustion efficiency, piping loss, and an extra pickup factor. We recommend sizing steam boilers based on the I=B=R rating.
309000 BTU
Thermal Efficiency
84.5 %
Ultra Low NOx Emissions
Ultra Low NOx Emissions
NOx is a byproduct of the combustion process, and it's output is regulated in some jurisdictions. Many regulators mirror SCAQMD rules, which regulate air quality for some parts of Southern California. Ultra Low NOx appliances emit less than 10-14 ng/J (nanogram per Joule) of NOx. Learn More
No
Electrical Data
Voltage
120 Volts
Phase
1
Frequency
60 Hz
Dimensions
Fluid Content
15.8 Gallons
Flue Connection Size
7 Inches
Supply Connection
2 1/2 Inches
Return Connection
2 1/2 Inches
Product Height
36 Inches
Product Width
33 Inches
Product Depth
26 Inches
Shipping Weight
1126 Pounds
Certifications
Country of Origin
United States
AHRI Certified
Yes
AHRI Reference Number
2120521
Warranty Information
Warranty
Warranty
A warranty is a safeguard from defects in manufacturing and can vary in length and terms. To see the manufacturer's warranty statement, click on the Manuals tab. Learn More
1 Year
Heat Exchanger Warranty
10 Years
Reviews
Crown Boiler Co. FW-4 Reviews & Ratings
Be the First to Write a Review
Do you own this product?
Please share your insights with fellow shoppers.
Please share your insights with fellow shoppers.
How-To Articles
How to Pick the Perfect Boiler
At the heart of every boiler heating system is the boiler itself. It's responsi...
Five Ways to Improve Boiler Efficiency
When purchasing a new boiler for your home, efficiency is the name of the game....
Hydronic System Accessory Guide
How warm does a coat keep you without gloves and a hat? Accessories are sometim...
Manuals
Ask A Question!
*Required Fields
+
Thank You For Submitting Your Question
Your submission has been sent successfully. Please give our experts up to two business days to respond.
Media Gallery
Crown Boiler FW - 355K BTU - 84.5% Thermal Efficiency - Hot Water Oil Boiler - Chimney Vent - Burner Sold Separately
Customer Review Images